Dieses Forum nutzt Cookies
Dieses Forum verwendet Cookies, um deine Login-Informationen zu speichern, wenn du registriert bist, und deinen letzten Besuch, wenn du es nicht bist. Cookies sind kleine Textdokumente, die auf deinem Computer gespeichert sind; Die von diesem Forum gesetzten Cookies düfen nur auf dieser Website verwendet werden und stellen kein Sicherheitsrisiko dar. Cookies auf diesem Forum speichern auch die spezifischen Themen, die du gelesen hast und wann du zum letzten Mal gelesen hast. Bitte bestätige, ob du diese Cookies akzeptierst oder ablehnst.

Ein Cookie wird in deinem Browser unabhängig von der Wahl gespeichert, um zu verhindern, dass dir diese Frage erneut gestellt wird. Du kannst deine Cookie-Einstellungen jederzeit über den Link in der Fußzeile ändern.
Hallo Gast
Das Forum wurde von der MyBB-Version 1.2.2 auf die aktuelle MyBB-Version 1.8.24. modifiziert womit alle Sicherheitslücken geschlossen wurden. Wichtig: Es könnte sein, dass Dein Passwort bei der Datenbankanpassung/-aktualisierung nicht mit übernommen werden konnte. Solltest Du bereits registriert gewesen sein, wurde Deine E-Mailadressen mit übernommen. Wenn Probleme beim Login bestehen (falsches Passwort), dann Bitte beim Login ein neues Passwort anfordern welches Dir an die bei der ursprünglichen Registrierung angegebene E-Mailadresse zugesandt wird. Danach mit dem zugesandten Passwort einloggen und im Benutzer-CP Dein gewünschtes Passwort neu eingeben. Dieser Vorgang muss nur einmalig ausgeführt werden. Besten Dank für Dein Verständnis.

Themabewertung:
  • 0 Bewertung(en) - 0 im Durchschnitt
  • 1
  • 2
  • 3
  • 4
  • 5
Speedometer sending unit frequency
#11
Hi,

I got the speedometer back from electrician last week and it turned out that it was a combined mistake. One problem was that the speedometer needle position was not correct. After correcting this, speedometer was still showing 100km/h when actual speed was 110km/h. This problem was solved by adjusting the potentiometer on the speedometer unit.
I haven’t road-tested it yet but on the table it was tested up to 160km/h and it showed correct speed the entire range.

BR,
Vigri
Zitieren
#12
Hi,

Can you please confirm precisely how you adjusted the potentiometer and where it is?

On my Ghibli I have a similar problem: whereas below 70 km/h speed is shown correctly (verified with GPS), above it shows up to 10 km/h less than the actual speed on GPS. (and my wheel size are correct). Showing more would be fine, but less is unacceptable.

Thanks for any help
Zitieren
#13
Hi,

These pictures are not from my speedometer but they tell the story.
Potentiometer is this “screw” marked red on the picture.
   
   
It is on the bottom side of speedometer connected to circuit board. It should be covered with silicon from factory to fix the position.
To adjust it just use a screwdriver. As I didn’t do it myself I cannot tell you how much and to what way you need to turn it but just start with little adjusting to either side and test how much it changes.
Because you need to take speedometer out from this plastic dashboard unit some people have drilled hole into it, so you could do it without removing it.
   

BR,
Vigri
Zitieren
#14
Thanks. When I un mount my dashboard the speedometer is not sticking out on the back side like on your third picture. I guess this means I would have to take apart the dashboard itself to access the screw.

Perhaps someone else can provide additional advice?
Zitieren
#15
Yes, just pull it of the pins man and adjust at the side like marked:

[Bild: tachorck.jpg]

Enrico, that Vigri cannot find those multiple posted tacho-issues via the German Suchfunktion I fully understand,- but why are you lazy slacker not using it???
Shoot5
Zitieren


Gehe zu:


Benutzer, die gerade dieses Thema anschauen: 1 Gast/Gäste